Tsymo Pet Feeder Manual Pdf (2024)

FAQs

Why is my pet feeder not connecting to Wi-Fi? ›

Make sure the feeder LED is blinking white which shows it is functioning and searching for Wi-Fi. Look at your Wi-Fi settings and make sure you are using a 2.4gHz network. Check if any firewalls are activated on your router to keeping it from connecting. Power cycle the feeder by turning off the power switch.

Reset the feeder to factory settings, holding down the Add Pet ( ) button for 10 seconds (until the light starts alternating red / green and the lid opens and closes).

Microchip Pet Feeders and Connect Pet Feeders:

Please note that when the lid remains open and the orange light flashes, this indicates that the feeder is in 'training mode'. Please press and hold the 'Fn'/training button for 10 seconds to deactivate the training mode.

Press and hold the Up button and the Down button for three seconds to reset the feeder to factory settings.

The LED on the product will flash red every 4-5 seconds when the batteries need changing.

The device has a lithium battery. If you do not need to use the device for an extended period of time, you must turn the device off yourself. At the same time, hold down the bowl reset button together with the manual food dispenser button for 5 seconds.

Yellow Blinking Feeder has power and is in setup mode. Yellow Solid Smartphone is connected to the feeder in setup mode. Blue Blinking Slow Feeder is connected to Wi-Fi but no internet. Blue Blinking Fast Feeder is trying to connect to Wi-Fi or is offline.